
Weldless Bulkhead Fitting - 1/2in. FPT x 1/2in. MPT
This unique and low profile bulkhead fitting is perfect on any pot, be it kettle, mash tun or lauter tun. It also works very well in cooler type mash tuns. It boasts a 1/2" Male NPT Nipple on the exterior side and 1/2" Female NPT for the interior, as well as 3/4" Male NPT on the exterior. Comes complete with a flat washer and thick rubber washer to ensure easy installation.
Completely Stainless Steel.
QUESTIONS & ANSWERS
Ask a Question-
I have a 1.125" (1 & 1/8") inch hole, will there be too much play if I attempt to use this bulkhead fitting?
A 1.125" hole will put you right about the middle of the flat washer and O ring. As long as it's installed correctly and tightened well, it will work just fine. It is a little bit, but only by 1/16" on either side of the bulkhead, so it should work just fine.
-
What hole size in kettle is needed for this?
You will need a 1" hole in your kettle or cooler to use this fitting.
-
Do you have any 2 inch x 12 inch reflux column that are no weld
The Still Spirits Turbo 500 is weldless, and can be used in this capacity.